HPSP-12512

The HPSP-12512 is a high power, high performance DC-to-DC converter that supplies three outputs that are programmable up to 24V output and supports an ultra wide input range of 6-50V. The HPSP-12512 has two power inputs protected with heavy-duty transient surge stoppers that clamps the input voltage to safe levels. The HPSP is ideal for battery and unregulated input applications. The HPSP uses a flash based microcontroller to supply advanced power management that monitors and controls the operation of the HPSP through a RS232 serial port.

The HPSP-12512 is a state-of-the-art Mosfet based design that provides outstanding line and load regulation and high efficiency. The low noise design makes the HPSP ideal for use aboard aircraft or military applications or wherever EMI or RFI must be minimized.

The HPSP-12512 advanced power management functions provide timed on/off control, notification of changes to main power and secondary power status.

The HPSP is PC/104 footprint in size of 3.55 x 3.775 inches with the same mounting holes pattern. However, the HPSP does not include the PC/104 bus connectors. All generated voltages are provided to a removable header. A removable plug allows the HPSP to be easily installed. The RS232 serial port is provided on a 2×5 row pin header.

The HPSP-12512 can also be configured to be signal compatible to an ATX power supply.  However, it does not provide -5V, -12V that standard ATX supplies include but the three outputs can be programmed to provide the standard 3.3V, 5V and 12V.

Advantages

> DC to DC converter for embedded applications.
> “Load Dump” transient suppression on both main and secondary power supply inputs.
> Operates from super wide 6VDC to 50VDC input.
> PC/104 size and mounting holes.
> Three main programmable outputs OUT1, OUT2 & OUT3. A 1.5A 5VSB outputs is also provided.
> Temperature range -40 to 85degC (measured on heat spreader).
> Complete with built-in digital temperature sensor.
> RS232 serial port for setup, monitoring and control.
> Opto-coupled inputs for ignition, and system “shut-down” push-button.
> Can be configured to be ATX compatible